Date: 09.02.2004
Component: Steering > Column Locking > Anti-theft Device
Manufacturer: General Motors Corp.
Description:
On certain passenger vehicles equipped with electronic column lock systems (ecl), when the ignition switch is turned to "lock," the ecl system prevents turning of the steering system. when the vehicle is started, the ecl unlocks the steering system. the vehicle is designed so that if the column fails to unlock when the vehicle is started and the customer tries to drive, the fuel supply will be shut off so that the vehicle cannot move when the vehicle cannot be steered. if voltage at the powertrain control module is low or interrupted, however, the fuel shut off may not occur and the vehicle can be accelerated while the steering system is locked. also when the control system shows that the ecl is unlocked and the vehicle is being driven, the lock pin location can vary. depending on the location of the lock plate relative to the switch transition point, there could then be contact between the lock plate and pin causing the steering to lock while driving .
Consequencs:
If this occurs, a crash could occur without warning.
Notes:
On vehicles equipped with an automatic transmission, the dealer will disable the steering column lock by removing the column lock plate. when the ignition key is removed, the transmission shifter will lock but the steering column will not lock. on vehicles equipped with a manual transmission, the dealer will reprogram the powertrain control module, perform a dimensional check of the column lock and, if necessary, replace the lock plate. the steering column on these vehicles will continue to lock when the key is removed. owner notification to owners of 1997 vehicles equipped with automatic transmissions began on april 26, 2004. owners of 1998 through 2004 vehicles (except 1997-1998 manual transmission vehicles) will be notified beginning on august 2, 2004. the remaining owners (1997-1998 manual transmission vehicles) will be notified later in 2004, when parts are available. owners should contact chevrolet at 1-800-630-2438.
Date: 03.11.2004
Component: Service Brakes, Hydraulic > Foundation Components > Hoses, Lines/piping, And Fittings
Manufacturer: General Motors Corp.
Description:
Certain passenger vehicles were produced with one or both rear brake hydraulic lines that can come in contact with or be affected by heat from the left engine exhaust manifold and the left exhaust pipe. the brake fluid could reach elevated temperatures and boil.
Consequencs:
If the brake fluid boils in a rear brake line, the effectiveness of the rear brake system would be reduced which could result in a brake line leak and loss of brake fluid. if enough fluid leaks from the rear brake system so that brake pedal application can no longer build pressure to the rear brakes. the operator of the vehicle will experience limited braking which could result in a crash.
Notes:
Dealers will (1) inspect the left engine exhaust manifold clip for proper alignment and placement on the body-mounted stud. if incorrect, they will reposition the clip on the brake lines and reinstall the clip on the stud; (2) the dealer will verify that both rear brake lines have the proper clearance to the left exhaust pipe. they will reposition the lines by bending as necessary; (3) dealers will remove the machining tab from the rear differential housing. also, dealers are to inspect the brake lines for wear in these related areas and repair or replace if there is any sign of wear-through on the nylon overcoating. the recall began on january 18, 2005. owners should contact cadillac at 1-866-982-2239 or chevrolet at 1-800-630-2438.
Date: 09.06.2004
Component: Steering > Linkages
Manufacturer: General Motors Corp.
Description:
On certain passenger vehicles involved in this campaign, the lower control arm ball stud nut/washer assemblies with washers were made of the wrong material. the washers may fracture and become loose or fall away from the vehicle, reducing clamp load. separation of the control arm ball stud and steering knuckle, due to disengagement of the tapered attachment and retaining nut, is possible.
Consequencs:
If the control arm separates from the knuckle, the affected corner of the vehicle will drop and the control arm would be forced downward, contacting the wheel. the affected wheel could tilt outward and create a dragging action that would tend to slow the vehicle and create a tendency for the vehicle to turn in the direction of the affected wheel. in extreme situations, the affected wheel assembly could separate from the vehicle. separation of the wheel assembly would also sever that wheel;s hydraulic brake hose and result in diminished braking performance of the vehicle, which could result in a crash.
Notes:
Dealers will inspect the ball stud joints and measure the torque of the nut for all front lower control arms in all models affected as well as the rear lower control arms on the xlr and corvette. if the torque is not at specification, the dealers will replace the ball stud, the knuckle, and the nut. if the torque is at specification, the dealers will replace the nut/washer assembly only. the recall will begin on august 25, 2004. owners should contact cadillac at 1-866-982-2339 or chevrolet at 1-800-630-2438.
Date: 24.05.2006
Component: Structure > Body > Roof And Pillars
Manufacturer: General Motors Corp.
Description:
On certain 2005-2006 chevrolet corvettes equipped with painted roofs, the adhesive between the roof panel and the frame may separate.
Consequencs:
If there is a complete separation, the roof panel may detach from the vehicle and it could strike another vehicle and cause injury and property damage.
Notes:
Dealers will inspect vehicles free of charge for potential roof panel-to- frame separation and add the specified adhesive foam or replace the roof with one having adhesive foam. the recall began on october 19, 2006. owners may contact chevrolet at 1-800-630-2438.
Date: 14.05.2014
Component: Electrical System > Wiring
Manufacturer: General Motors Llc
Description:
General motors llc (gm) is recalling certain model year 2005-2007 chevrolet corvette vehicles manufactured march 29, 2004, through june 22, 2007. in the affected vehicles, the underhood bussed electrical center (ubec) housing can expand and cause the headlamp low beam relay control circuit wire to bend. if the wire is repeatedly bent, it may fracture causing a loss of low beam headlamp illumination.
Consequencs:
The loss of low beam headlamp illumination will decrease the driver's visibility, as well as the vehicle's conspicuity to other motorists, increasing the risk of a crash.
Notes:
Gm will notify owners, and dealers will install a jumper wire to correct this condition, free of charge. the manufacturer has not yet provided a notification schedule. interim letter for 2005-2007 model years distributed on july 14, 2014. owners may contact chevrolet customer service at 1-800-222-1020. gm's number for this recall is 13146. note: model year 2008-2013 chevrolet corvettes will be covered under customer satisfaction program number 14203 for the same issue.
Date: 14.05.2014
Component: Exterior Lighting > Headlights
Manufacturer: General Motors Llc
Description:
General motors llc (gm) is recalling certain model year 2005-2007 chevrolet corvette vehicles manufactured march 29, 2004, through june 22, 2007. in the affected vehicles, the underhood bussed electrical center (ubec) housing can expand and cause the headlamp low beam relay control circuit wire to bend. if the wire is repeatedly bent, it may fracture causing a loss of low beam headlamp illumination.
Consequencs:
The loss of low beam headlamp illumination will decrease the driver's visibility, as well as the vehicle's conspicuity to other motorists, increasing the risk of a crash.
Notes:
Gm will notify owners, and dealers will install a jumper wire to correct this condition, free of charge. the manufacturer has not yet provided a notification schedule. interim letter for 2005-2007 model years distributed on july 14, 2014. owners may contact chevrolet customer service at 1-800-222-1020. gm's number for this recall is 13146. note: model year 2008-2013 chevrolet corvettes will be covered under customer satisfaction program number 14203 for the same issue.
Date: 23.12.2009
Component: Structure > Body > Roof And Pillars
Manufacturer: General Motors Corp.
Description:
General motors is recalling certain model year 2005 through 2007 corvette vehicles equipped with a removable roof and model year 2006 and 2007 corvette z06 vehicles. the adhesive between the roof panel and the frame may separate. if there is a partial separation, the driver may notice one or more symptoms, such as a snapping noise when driving over bumps, wind noise, poor roof panel fit, roof panel movement/bounce when a door or hatch is closed, or a water leak in the headliner.
Consequencs:
If there is a complete separation, the roof panel may detach from the vehicle. if this were to occur while the vehicle was being driven, it could strike a following vehicle and cause injury and/or property damage.
Notes:
Dealers will install a new design roof panel free of charge. the safety recall is expected to begin during april 2010. owners may contact chevrolet at 1-800-630-2438 or at www.gmownercenter.com.
Date: 23.12.2009
Component: Structure > Body > Roof And Pillars
Manufacturer: General Motors Corp.
Description:
General motors is recalling certain model year 2005 through 2007 corvette vehicles equipped with a removable roof and model year 2006 and 2007 corvette z06 vehicles. the adhesive between the roof panel and the frame may separate. if there is a partial separation, the driver may notice one or more symptoms, such as a snapping noise when driving over bumps, wind noise, poor roof panel fit, roof panel movement/bounce when a door or hatch is closed, or a water leak in the headliner.
Consequencs:
If there is a complete separation, the roof panel may detach from the vehicle. if this were to occur while the vehicle was being driven, it could strike a following vehicle and cause injury and/or property damage.
Notes:
Dealers will install a new design roof panel free of charge. the safety recall is expected to begin during april 2010. owners may contact chevrolet at 1-800-630-2438 or at www.gmownercenter.com.
Date: 23.12.2009
Component: Structure > Body > Roof And Pillars
Manufacturer: General Motors Corp.
Description:
General motors is recalling certain model year 2005 through 2007 corvette vehicles equipped with a removable roof and model year 2006 and 2007 corvette z06 vehicles. the adhesive between the roof panel and the frame may separate. if there is a partial separation, the driver may notice one or more symptoms, such as a snapping noise when driving over bumps, wind noise, poor roof panel fit, roof panel movement/bounce when a door or hatch is closed, or a water leak in the headliner.
Consequencs:
If there is a complete separation, the roof panel may detach from the vehicle. if this were to occur while the vehicle was being driven, it could strike a following vehicle and cause injury and/or property damage.
Notes:
Dealers will install a new design roof panel free of charge. the safety recall is expected to begin during april 2010. owners may contact chevrolet at 1-800-630-2438 or at www.gmownercenter.com.
Date: 26.04.2010
Component: Steering > Column
Manufacturer: General Motors Corp.
Description:
Gm is recalling certain model year 2005 and 2006 chevrolet corvette passenger cars manufactured between march 2004 and january 2006 equipped with a tilt and telescoping steering column (rpo n37). in rare cases, repeated movement of the steering column may cause a signal interruption within the column. if this occurs, the message, "service active handling system" will appear in the driver information center, and one or more of the brakes may apply, possibly causing the vehicle to pull to the right or left.
Consequencs:
If the driver does not respond to the change in vehicle movement, a crash could occur.
Notes:
Gm will notify owners and dealers will repair the vehicles free of charge. the safety recall began on april 30, 2010. owners may contact chevrolet at 1-800-630-2438 and gmc at 1-866-996-9463 or at the owner center at www.gmownercenter.com.
Date: 26.04.2010
Component: Steering > Column
Manufacturer: General Motors Corp.
Description:
Gm is recalling certain model year 2005 and 2006 chevrolet corvette passenger cars manufactured between march 2004 and january 2006 equipped with a tilt and telescoping steering column (rpo n37). in rare cases, repeated movement of the steering column may cause a signal interruption within the column. if this occurs, the message, "service active handling system" will appear in the driver information center, and one or more of the brakes may apply, possibly causing the vehicle to pull to the right or left.
Consequencs:
If the driver does not respond to the change in vehicle movement, a crash could occur.
Notes:
Gm will notify owners and dealers will repair the vehicles free of charge. the safety recall began on april 30, 2010. owners may contact chevrolet at 1-800-630-2438 and gmc at 1-866-996-9463 or at the owner center at www.gmownercenter.com.
