Report for VIN 3GKEC16T91G167480

Overview

VIN: 3GKEC16T91G167480
Make: GMC
Model: Yukon XL
Variant: 1500 2WD
Year: 2001

Vehicle history

History records: Get history report
User messages: View / add messages (0)
Recalls: View recalls (3)
Complaints:
Service bulletins:

Junk, salvage, damages

Check for collision, salvage, junk, total-loss, fire, hail, flood, rebuild, thief, odometer rollbacks, odometer readings, etc. records:

Technical specification

Bodytype: Sport Utility
Doors: 4
Seats: 9
Engine ccm: 5300
Engine type: V8 OHV 16V
Height (inch): 75.80
Width (inch): 78.80
Length (inch): 219.30
Steering: Recirc
Anti-brake system: 4-Wheel ABS

Tyres and wheels

Tyre:
Wheels:

Fuel economy

Tank size (gallon): 32.50
Highway Mileage (miles/gallon): 18
City Mileage (miles/gallon): 14

Other information

Model year:
Model period:
Manufacturer:
Place of assembly: MEXICO
Market:
WMI / VDS / VIS: 3GK / EC16T9 / 1G167480
Sequential number: 67480
VIN checksum: Valid

Vehicle recalls

Date: 29.08.2005
Component: Service Brakes, Hydraulic > Antilock
Manufacturer: General Motors Corp.
Description:
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (abs) activation. this condition is more likely to occur in environmentally corrosive areas. this recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Consequencs:
This can cause increased stopping distances during low-speed brake applications, which could result in a crash.
Notes:
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. the recall began september 22, 2005. owners may contact chevrolet at 1-800-630-2438 or gmc at 1-866-996-9463.
Date: 14.04.2005
Component: Fuel System, Gasoline > Delivery > Fuel Pump
Manufacturer: General Motors Corp.
Description:
Certain trucks and sport utility vehicles were built with fuel module reservoir assemblies that contain fuel pump wires connectors may overheat under certain operating conditions.
Consequencs:
If the ignition circuit wire is exposed, the fuel pump fuse will blow, disabling the fuel pump and causing an engine stall or no-start condition. if sufficient heat is conducted to the pass-through connector, a hole in the connector may result, which may cause a 'service engine soon' light to be illuminated during the emission system diagnostic routine. fuel vapor and in some cases liquid fuel may leak out of the fuel tank through the hole in the connector body. fuel leakage, in the presence of an ignition source, could result in a fire. also if the ignition circuit or ground wire is exposed and shorts to the fuel level sender card wires, inaccurate fuel level readings may result.
Notes:
Dealers will remove the fuel tank, and remove the module reservoir assemblies from the tank, and install a new service kit free of charge. an interim letter to owners was mailed on may 25, 2005. the owners were re-notified on october 19, 2005, since parts are now availabe. owners may contact chevrolet at 1-800-630-2438 and gmc at 1-866-996-9463.
Date: 29.08.2005
Component: Service Brakes, Hydraulic > Antilock
Manufacturer: General Motors Corp.
Description:
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (abs) activation. this condition is more likely to occur in environmentally corrosive areas. this recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
Consequencs:
This can cause increased stopping distances during low-speed brake applications, which could result in a crash.
Notes:
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. the recall began september 22, 2005. owners may contact chevrolet at 1-800-630-2438 or gmc at 1-866-996-9463.
Show all recalls

Similar reports

Enter Your VIN and Get History Now:


GMC Yukon XL, 2001: list of valid VIN codes